Finished inGunmetal, these cute bar shapedlittle flip lockssit on the edge the finished edge of the front flap of any bag.They are so pretty and very easy to install!

These little cuties are not very deep inside and can really only handle a front flap that is about 1/8 (3mm) thick or one that can be compressed to be that thick (foam). I recommend a strong layer of bag stabilizer, such as Peltex, Timtex, or Fast2Fuse inside your front flap for strength.

Measurements:Width 2 3/8 (6 cm) x Height 3/8 (1 cm)

To install:

• Position the Bar Lockover the finished edge of a bag flap or strap closure and aremovable pen/marker/chalk to mark cutting holes. You can notch out the hole for the flip closure completely, but I would use a leather punch or awl to cut out the holes for the screws.
• Use clear drying fast grab glue such as Beacon 3-in-1, E-6000 or Gutterman glue on bothpieces so that they stay in place.
• Use a mini screw driver to screw in the 2 provided screws.
• Simply attach theflip parton the bag front using the provided washer, using the same technique as you would for any magnetic snap.

** Caution:This baglock could be bumped and flipped open. This please be sure to test and see if it suits your project.